This Is A Custom Widget

This Sliding Bar can be switched on or off in theme options, and can take any widget you throw at it or even fill it with your custom HTML Code. Its perfect for grabbing the attention of your viewers. Choose between 1, 2, 3 or 4 columns, set the background color, widget divider color, activate transparency, a top border or fully disable it on desktop and mobile.

This Is A Custom Widget

This Sliding Bar can be switched on or off in theme options, and can take any widget you throw at it or even fill it with your custom HTML Code. Its perfect for grabbing the attention of your viewers. Choose between 1, 2, 3 or 4 columns, set the background color, widget divider color, activate transparency, a top border or fully disable it on desktop and mobile.

Monthly Archives: June 2011

//June

Speeding Up Prototype PCB Designs – Finding New and Effective Formulas

By |June 27th, 2011|Printed Circuit Boards|

The consistent improvement of Prototype PCB designs provides a multitude of advantages to its end users. With new generation silicon such as 45nm and 95 nm being introduced, users are provided with Prototype PCBs that are a lot more functional at a lower cost and also at a lower power requirement. However, these improvements also [...]

Designing the Best Prototype PCBs – Trends You Should Consider

By |June 23rd, 2011|Printed Circuit Boards|

Designing the best Printed circuit boards or Prototype PCBs is continuously becoming a tough task to do for designers nowadays. The consecutive development of board designs along with the change of the demands of the end-users continue to push the designers and make them create new trends when it comes to designing the best Prototype [...]

PCB: An Overview Of The Printed Circuit Board

By |June 15th, 2011|Printed Circuit Boards|

There are two layers of each and every PCB. The first layer or the bottom layer is a conductive one and the second one is an insulating layer. The first layer is made of copper foils and the second one is made of prepared resin. The board is usually coated with a green color solder [...]

Understanding The Footprint Of A PCB

By |June 9th, 2011|Printed Circuit Boards|

When a "Printed Circuit Board" is designed and sent out for manufacturing, the manufacturer requires that a "footprint", essentially a map, be created for the board. This shows where the parts are to go on the PCB. On this copper pattern occasionally the whole outline of where specific components or parts are actually drawn in. [...]